|
|
|
|
|
|
   |
BATTERY BRUSH - PLASTIC By WIRTHCO
Easily removes rust and corrosion from battery posts and terminals. Metal bristles. Fits standard posts. Remove cap to reveal brush. Plastic case. |
|
|
  |
7610-SI-SERIES AUTOMATIC CHARGING RELAY By BLUE SEA SYSTEMS
•Protects sensitive electronics by temporary isolation of house loads from engine circuit during engine cranking •Designed for 12 or 24 volt systems •12/24 volt auto ranging voltage input •Hermetically sealed contacts/vaporproof •Waterproof rated IP67—temporary immersion for 30 minutes •Ignition protected—safe for installation aboard gasoline powered boats •Remote LED output indicates relay state away from ACR •Supports high-output alternators up to 120 Amperes •Dual sensing |
|
|
 |
ADD A BATTERY By BLUE SEA SYSTEMS
•A complete two battery bank management solution •Dual Circuit Plus™ Battery Switch isolates engine and house circuits, and combines battery banks for emergency starting •The 120 Amp SI ACR automatic charging relay combines batteries for charging |
|
|
 |
BATTERYLINK™ ACR By BLUE SEA SYSTEMS
CL-Series BatteryLink™ACR (Current Limiting) with Over Current Protection. Automatically combines battery banks when the higher battery has remained at the required voltage for at least 30 seconds. Disconnects when the voltage drops below the charging voltage to prevent accidental discharge of an unintended bank. Activates from any charging source - alternators, battery charger, or solar panels. Meets SAE J1171 - External ignition protection requirements. •Input Voltage: 9-16 volts maximum •Voltage Rating: 16 VDC for 12 VDC nominal systems •Contact Form: SPST-NO •Mechanical Life: 1,000,000 cycles |
|
|
|
|
|
|
  |
GUEST BATTERY ISOLATORS By MARINCO ELECTRICAL GROUP
The solid state device allows you to connect your engine alternator directly to both batteries without fear of overcharge, or of one higher-charged battery discharging into other lower-charged battery. Using this unique device, the batteries are electrically isolated from each other. Both your batteries are always automatically being charged whenever the engine is running. Rated for up to 70 amp alternator. For 6, 12, 24, 32 volt negative ground system. |
|
|
  |
BATTERY TERMINAL COVERS By MOELLER MFG CO INC
Made of neoprene rubber, a set of one black and one red cover. Size 2-1/2" x 1-1/4" ID, 1-5/8" high, will accept 3/4" OD terminal cable. Meets Coast Guard and BIA safety regulations requiring antishort protection for battery terminals. |
|
|
 |
THE POWER PLANT By MOELLER MFG CO INC
•The Power Plant holds 27, 30 & 31 series batteries •Non-corrosive hi-strength plastic construction •Easy-to-use one-touch charge indicator •12 Volt adapter built-in to lid (includes 10 amp fuse for added protection) •Complete with hold-down strap and mounting hardware |
|
|
  |
BATTERY CLEAN-UP™ By THE NOCO COMPANY
Battery Clean-Up™ instantly neutralizes, dissolves and removes corrosive elements from your battery terminals, cables, hold-downs and battery boxes. Formulated to assure maximum current flow and reduce potential voltage leakage. Battery Cleaner & Acid Detector detects, neutralizes and cleans acid build-up. A specialized yellow foaming agent turns pink upon contact with acid, notifying the user that acid is present. Great for removing corrosive elements from your battery terminals, cables, hold-downs and boxes. Assures maximum current flow and reduces potential voltage leakage. |
|
|
 |
BATTERY ISOLATOR GUARD By THE NOCO COMPANY
Battery isolator guards eliminate multiple battery drain, allow simultaneous charging of multiple batteries and prolong battery life. Features reliable solid-state circuitry. Completely sealed to protect against harsh environments, sun, salt water, oil and gas. Temperature range: -40°F to 250°F. Delcotron CS series battery isolator guards (12-36 VDC) are for General Motors (GM) Alternators for 1985 and newer vehicles that require an additional terminal for excitation of the alternator in the start and run positions only. Clamshell retail packaging. |
|
|
 |
NCP-2™ BATTERY CORROSION PREVENTATIVES By THE NOCO COMPANY
Since the early 1900's, NOCO has engineered and manufactured solutions for battery corrosion prevention. The world famous NCP-2 compound has prevented corrosion in more than 1 billion vehicles in 54 countries. Formulated to make all surfaces impenetrable to corrosion-causing acid fumes which reduce battery life and cranking ability. Suitable for battery terminals, cables, hold-downs, enclosures, boxes and carriers. Guaranteed for the life of your battery. •Stops battery corrosion •Prolongs battery life •Environmentally safe •Does not dry or evaporate •Resistant to reversion, atmospheric contamination, mechanical shock or vibration |
|
|
|
|
  |
BATTERY BOX TIE DOWN By RIG RITE MFG
•Marine grade Velcro strap has over 300 lbs. breaking strength to hold battery secure. •Makes battery installation and removal simple and easy. •Comes with mounting hardware. |
|
|
|
|
  |
ALL PURPOSE HOLDING STRAP By T-H MARINE
This 54" polypropylene strap provides a great way to secure any loose articles. The positive locking, quick disconnect buckle makes release a snap. Two footman loops and stainless mounting screws are included. |
|
|
|
|
